Using a Fireplace to Heat Your Home

March 16th, 2010 by Steve Evans

There are many reasons to select wood burning as your primary source of warmth right now. Some of the main factors being that it is environmentally valuable and it can be a cheaper solution to warm the house. In the following paragraphs, we will go over some tips and resource ideas for organizing your timber pile.

There are lots of excellent resources on the market that may help you get started with establishing your lumber pile to warm the house. One such resource is the Mantis Log Splitter. Straight away this will save you dollars on a rental or the alternative of buying huge amounts of lumber to warm your house.

Not only is heating your house with firewood cost-effective and environmentally good, creating a fire in your fireplace may be extremely soothing to your soul and home in general. You’ll find nothing like the sound of fire wood crackling within the fireplace as you go about your early morning.

Here are some tips for accumulating your source of fuel and the greatest uses of your electric log splitter.

Make sure you cut your lumber to an suitable length for the fireplace or stove. You will want to evaluate to make sure that it is a minimum of 3-4 inches shorter than the width of where you will be inserting it.

Make sure you work on your splitting method as wood which is split too big does not burn up adequately. You need to work to have a variety of sizes ranging from 3-6 inches in diameter for top burning results. You will want to measure or eyeball the bits of lumber at the biggest cross section of the firewood. Fire wood cut for the furnace may be just a bit greater compared to a stove or fireplace. It’s great to also have some kindling or smaller sized bits of wood accessible as this is the best to work with for getting your fire started.

For successful burning to take place, lumber can’t be wet and needs to have the dampness removed from it that it will naturally have. This does call for some organizing in advance with your wood purchase, splitting and drying method. An effective way to take out the water content from the firewood is really a pure method by letting the wind and sun dry them outside. Build your lumber pile in a spot where it may be warmed up by the sun, but the wind has the capacity to blow through it as well.

This really normally takes about 6 months for this drying method in order to make certain that all the dampness has been removed from the firewood. Because of this, you will need to begin this project in early spring to make sure that you have your lumber ready for the next winter cool months. Keep in mind though this depends mostly on where you live. Several parts of the world and the types of lumber that you locate there could take more time to dry so you will need to take this under consideration.

At this point it’s time to fire up the Mantis Electric Log Splitter, or your device of preference, and get to stacking that great wood stack. Winter weather will be here again before you know it and you will be sitting pretty by that very nice and soothing fire knowing that you are saving money and the environment in your choice to warm the house with wood.